Saturday, January 18, 2014

How to Make a USB Bootable

1. (Open Command Prompt as an Administrator) from start manue or by writing cmd in Run window.

2. (Open the disk management utility) by typing diskpart command in command prompt and then press enter.


3. (Display the connected disk to the pc) by typing list disk command in command prompt and then press enter your's USB is also listed here.


4. (Select the USB drive) by typing the select disk # , command in command prompt and then press enter (replace the # with the disk number of USB in previous step).


5. (Clean the flesh drive) by typing the clean command and then press enter.


6. (Create a bootable partition) by typing create partition primary command and then press enter.


7. (Select the new partition) by typing select partition 1 command and then press enter after receiving confirmation message, type active command and then press enter this will activate the partition. 


8. (Format USB Drive) by typing format fs=fat32 command and then press enter (this format peocess may be slow that take an hour) .


9. (Assign the USB a drive letter) by typing assign command and then press enter to give a letter designation. then type exit to end disk management utility.


10. (Copy the operating system) now copy the files of the operating system into the bootable USB drive you may also copy the drivers into the USB drive for your's easyness.


Thaks for visiting us Plz write your's comments bellow.........:)

No comments:

Post a Comment